OUR MISSION: To facilitate communication among glass artists, to encourage education and promote excellence in the glass arts.
 
 
 
 
 

                                          

 
Make sure the piece of glass is free of dust and oil and that there are no
sharp ledges. Find the flattest part of the glass piece to begin the foiling.

To get the foil to stick to the curve and fold over onto the glass with the
minimum of tears, use your fingers first to burnish the sides of the foil onto
the piece of glass beginning on the outside curve. 

As you move to the inside curved portion gently and progressively ease
the edge of the foil with your finger toward the surface of the glass.

Easing and burnishing one side of the curve at a time will give you better results toward getting the foil onto the glass without tearing the foil. 

Finish by burnishing the foil down using a fid.  This helps keep the foil firmly adhered to glass through the soldering.

Tears in the foil line happen.  Clean up the broken foil lines with a craft knife and the solder line will look nicer when project is finished.  You can also patch the tears by placing a small section of foil over the broken foil, burnish it, and trim with the craft knife.

[previous copper foiling tip]                                          [next copper foiling tip]

 



 
 
 

 

follow IGGA  follow IGGA

   foiling tight curves